03 mazda protege ball joint11/29/2023 Punching just helps to get it done faster, as well as keep the original walls within the pinch intact and not drill bit scarred. If it's no use, you can always drill both them out. Car Service Estimate Shop/Dealer Price 2003 Mazda Protege5 L4-2. Prices may vary depending on your location. You may not be able to punch it out at this point, but just keep drilling, stop, and try to punch. On average, the cost for a Mazda Protege5 Ball Joint Replacement (Front) is 223 with 128 for parts and 95 for labor. Fortunately, at this point it finally broke loose and the rest of the bolt that remained on the drilled side shot out and we were able to punch other the other piece of the remaining bolt by just hitting it from a different side. After about halfway through with your drilling, stop and try the hammer and punch. Drill little by little and remove your shavings. (It's good to have some motor oil handy by way of a cap full to dip your bit in so that it doesn't get too hot and generally help lubricate the bit.) After you have a good start, switch to the 10mm size. Then, we began drilling with a small bit to give a good pilot hole. We used a grinder and ground each side of bolt to a flat surface with the knuckle. With it cut in half it allows you to work independently of two smaller length seized bolts rather than one long one.( If you have to drill one out, one might only have to be punched out from the other side, which became the case for us.) (This is where having the control arm not in your way comes in handle). With the knuckle in the clamp, take your saw and cut the bolt stuck in the clamp in half. Now take your knuckle to your shop clamp. The ball joint is pressed into the new control arm (so it doesn't matter) and this allows you to not have to deal with a control arm and also provides another favor later. 2002 Mazda Protege L4-1.6L: Service type Ball Joint Front - Upper Right Replacement: Estimate 2517.86: Shop/Dealer Price 3097.96 - 4756.98: 2002 Mazda Protege L4-2.0L: Service type Ball Joint Front - Lower Left Replacement: Estimate 354.73: Shop/Dealer Price 429.68 - 632.00: 1997 Mazda Protege L4-1.8L: Service type Ball Joint Front. Then, what you are going to want to do is take your saw and cut the ball joint off the control arm. First, disconnect the tie rod, the bolts that connect the knuckle to the strut, take off the brakes, and rotor so that you are left with a knuckle stuck by way of a ball joint to the control arm. Beck/Arnley ball joints help maintain proper alignment with direct replacement. The following description is how we succeeded and replace the control arm with the ball joint stuck in the pinch and the bolt and nut that tighten the pitch rounded off and seized. Front lower ball joint for 1993-1998 Mazda Protege. But then we had a larger task ahead of having to get the bolt out of that pinch on the knuckle to replace the control arm. Pitch doesn't matter because the pinch isn't threaded.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |